It's dark out, but here ya go. Basically, I used the two silver clamps that came with kit on the far outside of the bar about 6 inches in on each side, double checking that it was straight. Then I used two 3/4 " NM Cable wood staples painted black, with #4 Stainless steel 1" screws to secure it in the middle about 14" inches apart. I wired it up with the Curt 55384 connector behind the bumper. For the reverse you tap into the middle white wire with a wire tap on the Curt connector. This way you don't need to touch or tap any factory wiring. I did it with the install with the tailgate on, because I like to makes things harder than they need to be. Good Luck with yours !